IOI Technology Corporation
Your I/O Solution Provider

U2H4+PSATA11S is an USB 2.0 four-port HUB with one USB to ATA/SATA bridge. U2H4+PSATA11S provides three downstream USB ports, one IDE (ATA/ATAPI) port and one SATA port. It is ideally suited for docking station solution which need more USB port and interface for connecting two ATA/SATA devices.
It allows ATA/SATA drives (Master and Slave) to be connected to USB 2.0 serial bus in a plug-and-play fashion.
The bundled backup software provides the perfect solution for data backup and transferring of data between computer and ATA/SATA HDD.

U2H4+PSATA11S combines two key components:

• 1). Four ports USB 2.0 High Speed Hub
• 2). USB 2.0 to ATA/SATA Bridge Board

1). Four ports USB 2.0 High Speed Hub:

U2H4+PSATA11S provides four downstream USB ports, with Single Transaction Translator (STT) for all ports, making it the cost effective hub solution.

The U2H4+PSATA11S works backward compatible either when any one of downstream ports are connected to an USB 1.1 compliant device, or when the upstream port is connected to a USB 1.1 compliant host.

• Compliant with USB 2.0(Data Rate 1.5/12/480Mbps)
  4 downstream ports
  • Two downstream ports (USB1&2) are Intel block berg-strip header (2x5/9 pin).
  • One downstream port (USB3) is Intel block berg-strip header (2x5/9 pin).
  • One downstream internal port for USB 2.0 to ATA/SATA Bridge Board
• Single transaction translator (STT)
  • Single transaction translator share the same TT control logics for all downstream port devices.
• All downstream facing ports can handle high-speed (480 Mbps), full-speed (12 Mbps), and low-speed (1.5 Mbps) transaction.
• Self-powered mode operation.
• Supports Over-current detection and Individual power control
• DC Power Connector: Floppy Disk Drive like mini 4-pin DC power connector
• USB 2.0 Interface: USB B-Type connector

2). USB 2.0 to ATA/SATA Bridge Board:

• IDE(ATA) Interface: Header 20x2 pin
• Serial ATA port: Signal (7pin) type connector
• Serial ATA Bus Transfer Rate: 1.5 Gbps
• Supports hot-plug & hot-swap feature of Serial ATA to USB.
• USB Bus Transfer Rate: High Speed (480 Mbit) And Full Speed (12 Mbit)
• Self-powered mode operation.
• Complies with T13's ATA/ATAPI-6 Draft Specification:
  • PIO Mode 0 ~ 4
  • Multi-Word DMA Mode 0 ~ 2
  • Ultra DMA Mode 0 ~ 5
  • Supports 48-bit addressing for large hard drives (>128GB)
• Complies with Gen1i and Gen1m of Serial ATA II Electronic Specification 1.0
• Power indicator LED and ATA/SATA Access LED

• 89.5 mm (W) x 62 mm(D)
• Form Factor
  • SCSI I 50pin Low Density Centronics Connector
  • Fit to most standard SCSI enclosure

• U2H4+PSATA11S Bridge Board
• CB-00136 - A Plug -to- B Plug USB 2.0 cable in length of 1.5m
• CB-00292 - Ultra DMA100 Cable 12+6 inch for two devices (Black - Gray - Black)
• CB-00334 - SATA plug to SATA plug Cable in length of 50cm (w/Latch)
• CB-00385 - SATA 15 pin to IDE Big 4 pin power Connector in length of 15cm
• Installation Guide
• CD-tilte (Driver for Windows 98/98SE, Backup Software)

Option:

• CB-00281 - Intel Block Standard 5x2/9pin Housing to two USB B Plug Cable
• CB-00378 - Intel Block Standard 5x2/9pin Housing to one USB B Plug Cable

• CE Test: Pass
• FCC Test : Pass
• VCCI Test: Pass
• BSMI Test: Pass

            

under construction

Q'ty	Carton size(cm)	N.W.	G.W.	Remark
NA	65x40.8x28.5	NA	NA	CT0001
NA	53.5x34x29	NA	NA	CT0009