4 downstream ports USB 3.0 HUB with PCI Breaket Form Factor

USB Hub

U3H401P

4 downstream ports USB 3.0 HUB with PCI Breaket Form Factor

Highlights

Supports USB 3.0 data transfer rate up to 5Gbps
Supports USB 3.0 SuperSpeed (5Gbps), USB 2.0 Hi-Speed (480Mbps), Full-Speed(12Mbps), and Low-Speed(1.5Mbps)
Supports one upstream port and four downstream ports
Form Factor

PCI Bracket Form Factor

Introduction

The U3H401P is a high-performance Universal Serial Bus (USB) 3.0 Hub.

U3H401P allows a single USB port to be used by up to four high-bandwidth USB 3.0 devices simultaneously.

U3H401P allows for a maximum data transfer rate of up to 5Gbps, or ten times the throughput available to USB 2.0 based devices. Other enhancements provide for improved interaction between device and host controller, including important advancements in power management.

One upstream port and four downstream ports support not just SuperSpeed transfer, but are also backwards compatible with previous USB specifications and offer support for Hi-Speed (480Mbps), Full-Speed (12Mbps), and Low-Speed (1.5Mbps) traffic.

Technical Specifications

Compliant to Universal Serial Bus 3.0 Specification Revision 1.0
Compliant to Universal Serial Bus Specification Revision 2.0
4 (max.) downstream facing ports. (Right angle USB A receptacle connector)
Supports USB 3.0 SuperSpeed (5Gbps), USB 2.0 Hi-Speed (480Mbps), Full-Speed(12Mbps), and Low-Speed (1.5Mbps)
Upstream port (Right angle USB B receptacle connector with Screw Holes for thumbscrew locking Type USB 3.0 Cable)
In-house USB PHY employing advanced CMOS process to consume less power
DC power input: Floppy drive like mini-4pin power connector (Min. DC +5V/2.5A)
Supports individual mode for power enable and over current detection on each down-stream port

Operating System Requirements